
Blue Only / Mono

Red and Green channels are not used and only Blue or Monochrome channel is used to display the screen. This function is used to adjust the color tones (tones and saturation) of the screen using the SMPTE Color Bar. For example, after displaying the Blue channel, adjust the Color (or Saturation) and Tint (or Hue) so that the original Magenta and Cyan are of the same brightness, and the original Gray and Blue are of the same brightness.
H/V Delay

Allows you to check the Blanking area and synchronize signals by displaying the horizontal and vertical intervals in the center of the screen.
Marker

Displays various kinds of aspect ratios on the screen. Wide range of markers and security areas are available with line color and curtain transparency selection. A User Marker is available if any of standard markers fits your requirements.
User Aspect



Adjusts the Width /Height display ratio.
Various Scan Modes



Controls the size of the image. Overscan: Extra area around the four edges of the image that may not be seen reliably by the viewer. Underscan: Constrains the size of the image so the monitor shows everything the camera is seeing. 1:1 pixel: Displays the original image resolution without scaling to match a certain resolution or an aspect ratio.
Waveform/Vector Scope


Waveform Y: Displays the Luma(Y’), Cb, Cr component of the input signal into waveform.
Vector Scope: Displays the color components ‘B-Y’ and ‘R-Y’of the input signals onto the X-Y axis.
Size | 31.1" |
Resolution | 4096 X 2160 (17 : 9) |
Pixe Pitch | 0.1704mm |
Color Depth | 1.07B |
Viewing Angle | 178°(H) / 178°(V) |
Luminance | 2,000cd/m2 |
Contrast Ratio | 1,000,000:1 |
Display Area | 698(H) x 368(V) mm |
4 X BNC | 12G-SDI A/B Channel Input, 3G-SDI C/D Channel Input |
1 X HDMI | HDMI Input |
4 X BNC | 12G-SDI A/B,3G-SDI C/D Channel (Loop Through Out) |
Audio Out | Analog Stereo (Phone Jack), Internal Speaker(Mono) |
, Blue Only, H/V Delay, Marker, Mono, User Aspect, Various Scan Modes, Waveform/Vector |
TVLogic Color Calibration Utility, 3rd Party 3D LUT Import |
REMOTE | TVLogic’s specification | |
USB | Firmware update by USB cable | Firmware update by USB memory stick |
Ethernet | ||
Conversion | SDI-to-SDI, |
Carring Case, |